Material Testing for SIGMASOFT
Material characterization considerations for SIGMASOFT simulations using thermoplastic and thermoset materials.
Read full postDatapoint Newsletter: Fall '17, Volume 23.4
CAETestBench Validation, Universal TestPaks, Matereality Analyzer Enhancement
Read full postThe Role of Material Data in the Simulation of Injection Molded Parts
The modeling of material behavior for injection molded plastics is a vital step for good simulation results. We detail the types of material data needed by various injection-molding simulation programs, factors that can affect simulation quality including test techniques and process variables such as moisture content. The case of fiber filled plastics is covered along with the extension to structural analysis applications.
Read full postThermoplastic Material Testing for Use in SIGMASOFT and the Effect of Moisture on PA 6/6
Thermoplastic materials are one of the largest categories of materials to be injection molded. Moisture-sensitive materials can lead to issues in the molding process. Simulation of the injection molding process requires sophisticated and exact material properties to be measured. This presentation discusses the testing required to characterize a thermoplastic material for use in SIGMASOFT, as well as the effects of moisture on viscosity measurement of a moisture-sensitive material. Consequences of basing designs on wet or dry materials are covered. Implementation of material data into the software to produce a successful injection molding simulation simulation is described.
Read full postSPE Newsletter - Summer '15
Molding Views, brought to you by the Injection Molding Division of the Society of Plastics Engineers
Read full postMold Tempering: Conformal Cooling - yes or no?
The tempering layout for injection molds is often designed departing from previous experiences. The manufacturing feasibility is the main driver when deciding where to place cooling lines. However, often the relevance of the tempering in the process profitability or in the part quality is underestimated, and due to the lack of better information sometimes the resulting tempering performs far from the optimum. As a consequence, the molding efficiency is reduced, the part quality is compromised and, once the mold is already built, sometimes expensive trial-and-error is required to bring the mold to an optimum configuration.
Read full postEjection system design: Optimization with SIGMASOFT Virtual Molding
As the demand for functional integration and the need of design differentiation in manufactured products increase, the complexity of plastic parts increases as well; thus some previous knowledge on effective ejection systems becomes insufficient and the challenges in the design of ejection systems grow consistently.
Read full postCold Runner Design - Getting the whole picture matters
The profitability of a molded rubber product depends to a large extent on the mold efficiency. To achieve the maximum productivity, besides the larges possible number of cavities it is desirable to minimize the rubber consumption and to produce parts without defects.
Read full postThermoplastic Material Testing for Use in SIGMASOFT
Thermoplastic materials are one of the largest categories of materials to be injection molded. Simulation of the injection molding process requires sophisticated and exact material properties to be measured. This presentation will discuss the testing required to characterize a material for use in SIGMASOFT, as well as the significance of material model parameters. Differences in testing methodology for amorphous and semi-crystalline polymers will be covered, along with step-by-step implementation into the software to produce a successful injection molding simulation simulation.
Read full post