Material Testing for SIGMASOFT
Material characterization considerations for SIGMASOFT simulations using thermoplastic and thermoset materials.
Read full postDatapoint Newsletter: Summer '19, Vol. 25.3
New DatapointLabs Website; High Temperature Crash Properties
Read full postDatapoint Newsletter: Winter '18, Vol. 24.1
Focus on Validation of Simulation: CAETestBench Validation for crash, additive manufacturing, injection molding, rubber hyperelasticity; Review of NAFEMS publication on V&V.
Read full postThe Role of Material Data in the Simulation of Injection Molded Parts
The modeling of material behavior for injection molded plastics is a vital step for good simulation results. We detail the types of material data needed by various injection-molding simulation programs, factors that can affect simulation quality including test techniques and process variables such as moisture content. The case of fiber filled plastics is covered along with the extension to structural analysis applications.
Read full postWorkshop: Testing, Modeling and Validation for Plastics & Rubber Simulation in ANSYS
Plastics exhibit non-linear viscoelastic behavior followed by a combination of deviatoric and volumetric plastic deformation until failure. Capturing these phenomena correctly in simulation presents a challenge because of limitations in commonly used material models. We follow an approach where we outline the general behavioral phenomena, then prescribe material models for handling different phases of plastics deformation. Edge cases will then be covered to complete the picture. Topics to be addressed include: Using elasto-plasticity; When to use hyperelasticity; Brittle polymers – filled plastics; Failure modes to consider; Criteria for survival; Choosing materials; Spatial non-isotropy from injection molding; Importance of residual stress; Visco-elastic and creep effects; Strain-rate effects for drop test and crash simulations; Fitting material data to FEA material models; The use of mid-stage validation as a tool to confirm the quality of simulation before use in real-life applications.
Read full postFrom Manufacturing to Design Validation
[We] introduced the topic of injection molding process simulation and the influence of the manufacturing process on structural analysis. The strength and stiffness of a part can be inaccurately represented if the manufacturing process conditions are not properly considered. This results in a different calculation of system natural frequencies or improper estimation of the energy absorbing characteristics. We continue on this topic, extending the scope to advanced technologies available in the Altair Partner Alliance (APA) to help solve the problem of proper design validation with fiber reinforced plastics.
Read full postThermoplastic Material Testing for Use in SIGMASOFT and the Effect of Moisture on PA 6/6
Thermoplastic materials are one of the largest categories of materials to be injection molded. Moisture-sensitive materials can lead to issues in the molding process. Simulation of the injection molding process requires sophisticated and exact material properties to be measured. This presentation discusses the testing required to characterize a thermoplastic material for use in SIGMASOFT, as well as the effects of moisture on viscosity measurement of a moisture-sensitive material. Consequences of basing designs on wet or dry materials are covered. Implementation of material data into the software to produce a successful injection molding simulation simulation is described.
Read full postSPE Newsletter - Summer '15
Molding Views, brought to you by the Injection Molding Division of the Society of Plastics Engineers
Read full postMold Tempering: Conformal Cooling - yes or no?
The tempering layout for injection molds is often designed departing from previous experiences. The manufacturing feasibility is the main driver when deciding where to place cooling lines. However, often the relevance of the tempering in the process profitability or in the part quality is underestimated, and due to the lack of better information sometimes the resulting tempering performs far from the optimum. As a consequence, the molding efficiency is reduced, the part quality is compromised and, once the mold is already built, sometimes expensive trial-and-error is required to bring the mold to an optimum configuration.
Read full post