Materials in simulation
Know your materials
Practical knowledge for simulation professionals who need to understand how material behavior is tested, modeled, and represented in FEA.
Comparison of Crash Models for Ductile Plastics
There is interest in quantifying the accuracy of different material models being used in LS-DYNA today for the modeling of plastics. In our study, we characterize two ductile, yet different materials, ABS and polypropylene for rate dependent tensile properties and use the data to develop material parameters for the material models commonly used for plastics: MAT_024 and its variants, MAT_089 and MAT_187. We then perform a falling dart impact test which produces a complex multi-axial stress state and simulate this experiment using LS-DYNA. For each material model we are able to compare simulation to actual experiment thereby obtaining a measure of fidelity of the simulation to reality. In this way, we can assess the benefits of using a particular material model for plastics simulation.
Read full postA Simplified Approach to the Simulation of Rubber-like Materials under Dynamic Loading
"The simulation of rubber materials is becoming increasingly important in automotive crashworthiness simulations. Although highly sophisticated material laws are available in LS-DYNA to model rubber parts, the determination of material properties can be non-trivial and time consuming. In many applications, the rubber component is mainly loaded uniaxially at rather high strain rates. In this paper a simplified material model for rubber is presented allowing for a fast generation of input data based on uniaxial static and dynamic test data."
Read full postDatapoint Newsletter: Winter '15, Volume 21.1
DatapointLabs Celebrates 20 Years of Putting Materials into Product Design, Very High Strain-Rate Tensile Testing Up to 1000 /s, New Long Term Stress Relaxation Capability, Expanded Creep Testing Capacity
Read full postChallenges in the Modeling of Plastics in Computer Simulation
Finite-element analysis and injection-molding simulation are two technologies that are seeing widespread use today in the design of plastic components. Limitations exist in our ability to mathematically describe the complexity of polymer behavior to these software packages. Material models commonly used in finite-element analysis were not designed for plastics, making it difficult to correctly describe non-linear behavior and plasticity of these complex materials. Time-based viscoelastic phenomena further complicate analysis. Dealing with fiber fillers brings yet another layer of complexity. It is vital to the plastics engineer to comprehend these gaps in order to make good design decisions. Approaches to understanding and dealing with these challenges, including practical strategies for everyday use, will be discussed.
Read full postThermoplastic Material Testing for Use in SIGMASOFT
Thermoplastic materials are one of the largest categories of materials to be injection molded. Simulation of the injection molding process requires sophisticated and exact material properties to be measured. This presentation will discuss the testing required to characterize a material for use in SIGMASOFT, as well as the significance of material model parameters. Differences in testing methodology for amorphous and semi-crystalline polymers will be covered, along with step-by-step implementation into the software to produce a successful injection molding simulation simulation.
Read full postDatapoint Newsletter: Late Fall '14, Volume 20.4a
DatapointLabs Adopts Matereality for Direct Deposit of Materials Testing Deliverables, Seminar Review: Accurate FEA of Engineering Plastics
Read full postValidation of Simulation Results Through Use of DIC Techniques
It has long been desired to quantify the accuracy of simulation results. Through developments in digital image correlation (DIC) techniques, it is now possible to quantify the deviation between simulation and real life experimentation. In this paper, three-dimension DIC measurements of deformed parts are compared to deformed surfaces predicted in simulation. Using DIC, it is possible to import deformed surface elements from simulation and map the magnitude of deviation from the measurements of the actual deformed shape.
Read full post